Making Stays/Shrouds click here to read or make an observation about this  article
By David "Shorty" Routh - Phoenix, Arizona - USA

There numerous methods for making wire stays for your sailboat. This essay presents a simple method using nicopress ferrule cable clamp fittings which are swaged on using a cheap swaging tool. The toughest part seems to be figuring how how long to make the stays, this essay presents 2 methods.

click to enlarge

Method 1 - Measure & Pray

(click images for larger views)

If you are replacing an existing stay on a sail boat, you might have the old one and will know how long it needs to be. Or if you are setting up a new rig, you can use trigonometry or scale drawings to calculate how long your stay needs to be. Make sure to pray a lot while doing your calculations and take into consideration how long your mast & hull connections are, it sure is agrevating to make the wrong size stay - but not completely hopeless. There are a large variety of variable sized stay adjuster, tangs and stay extenders incase you make one too small.

After this is known, you then have to figure how long of a piece of wire to cut. This wire must be long enough to span the distance, plus go around the timble and back into the ferrules. You can calculate how much extra wire is needed by laying out the ferrules and rolling the thimble along the wire. Then it is just a matter of crimping on the connectors.

click to enlarge

Method 2 - Setup & Cut

This is a quick and easy way to make a set of stays. First you need to get a general sense of how long the stay needs to be. Measure the distance from the mast step to the chain plate. Then clamp one end of a measure tape to the mast. Use a 2nd measure tape to get the side distance and presto, you have a good idea how long they are going to be.

Make a set of stays with only one end swaged and attach them to the mast.

click to enlarge

Setup your mast holding it upright with ropes. The ropes should be tied to the hull much further back than the chain plates so that they won't have as much tension on them. Tie the side ropes to the stern corners if you can, or thru the oar locks.

Setup your wire on the stay adjusters with their thimbles and ferrules.

click to enlarge

Use a screw on type cable clamp to hold the wire so you can crimp it. Setup all of the stays this way and take a good look at the rig. Adjust as needed.

I prefer to setup my stays so they are in the 2nd hole down. This allows me to loosen one or the other incase I screwed up and have the mast leaning enough to be noticed. Also it allows for the wire to stretch and gives me room to tighten it down later.

Now you are ready to start crimping.

click to enlarge

There is a special wire vice with 3 form fitting jaws that you can use to hold the wire while crimping, but I found this method is good enough for what I do.

This is a cheap swage-it tool. You can get one from Duckworks

click to enlarge

It is just a pair of bars with bolts to create the clamping pressure. The bars have several half moon shapes in them to fit the different sized ferrules.

Here is the finished product, this is the forestay.

click to enlarge

I even crimp the quick pin onto the stay adjuster with a safety wire so I won't drop it in the drink.

Other articles by David "Shorty" Routh: