|
Tombstone is a Dory-ish
one sheet boat. The rear transom is made out of scrap or 1x lumber.
Waterline is at 200 lbs displacement, with a boat weight of 35 lbs
or so. Good for a kid or light adult. Stitch and Glue construction.
Seating up to the builder. Not recommended for sail.
|
Bottom Panel
Half |
|
Station |
X |
Y |
X2 |
Y2 |
|
1 |
0
|
0
|
0
|
3 15/16 |
|
2 |
12
|
0
|
12
|
8 1/2
|
|
3 |
24
|
0
|
24
|
11 1/16 |
|
4 |
36
|
0
|
36
|
12
|
|
5 |
48
|
0
|
48
|
11 7/8
|
|
6 |
60
|
0
|
60
|
10 3/4
|
|
7 |
72
|
0
|
72
|
7 11/16 |
|
8 |
84
|
0
|
84
|
2 3/8
|
|
9 |
87 7/8
|
0
|
87 7/8
|
0
|
|
|
|
Side Panel First
Chine |
|
Station |
X |
Y |
X2 |
Y2 |
|
1 |
0
|
2 3/16 |
0
|
9 5/16 |
|
2 |
12
|
15/16 |
12
|
10 3/16 |
|
3 |
24
|
5/16 |
24
|
10 11/16 |
|
4 |
36
|
0
|
36
|
11 1/16 |
|
5 |
48
|
0
|
48
|
11 5/16 |
|
6 |
60
|
5/16 |
60
|
11 3/8
|
|
7 |
72
|
3/4
|
72
|
11 1/4
|
|
8 |
84
|
1 9/16 |
84
|
10 7/8
|
|
9 |
91 1/8
|
2 3/16 |
N/A |
N/A |
|
10 |
N/A |
N/A |
95
|
10 3/8
|
|
|
|
Transom Half |
|
|
|
Station |
X |
Y |
|
|
|
1 |
0
|
3 15/16 |
|
|
|
2 |
6 7/8
|
5 13/16 |
|
|
All
measurements are in inches.
The end points of the plotted lines are joined by a straight line.
This shows how the measurements are used to lay
out the panels. X and Y are the bottom line of the panel and X2 and Y2 are
the top line. All points are from the edge of the ply or a baseline. Any
points which are N/A are not plotted. They may just be not on the panel or
are not important to that line. The two end points are closed with a
straight line.
For information on Stitch and Glue, please check
the construction of fisher10. The hull was done entirely with stitch and
glue, except for the transom/side panel joint, which was first attached
with screws and then filleted on the inside and taped on the outside.
There are also many good sites with Stitch and glue information.
www.bateau.com has an excellent primer on the subject, so do most of
the other major plans dealers, such as Glenn-L and Clark Craft. |
